Operation Manual

Frama Matrix F2
31
6. Counter readings and cost centres
6.1. Cost centres
Your Frama Matrix F2 is equipped with various counters which
allow you to monitor the postage usage and the number of
mail items franked.
Additionally, the postage used and the numbers of mail items
are booked against the respective cost centres. These
counters are designated R-Piece and R-Value (R = resetable).
Two cost centres are available to you. The current cost centre
is always shown at the top on the left in the franking page.
Press this key in the franking page to change the cost centre.
Select the desired cost centre and, if necessary, enter the
required PIN.
You maintain and set up the cost centres in the administration mode.
6.2. Counter readings
You can have the current counter readings shown at any time.
To do so, use the franking page and press “i” repeatedly until
the counter readings appear. In addition, you can print out
the counter readings via the function “Info Print”.
Meanings of various counters:
Total: Total counter readings of the franking system (pieces and values franked) since the cost centre
became operational. Owing to in-depth tests carried out before your Frama Matrix F2 was delivered,
the total number counter might already show an initial figure.
Reset Value / Piece: Resettable counters of your franking system. Every cost centre has resettable
counters. The resettable counter of the franking system can be reset in the administration mode.
Credit: This is the postage still available in your franking system.
All screens shown in this chapter are for reference only and may differ from
your local presentation.