Operation Manual

Frama Matrix F2
20
4.3. Franking
Always first connect the supply unit with your Frama Matrix F2 and only then with the mains power
supply. Normally, you should always leave the system switched on .
4.3.1. Entering code (logging in)
To be able to work with your Frama Matrix F2, you have to
enter a PIN for every cost centre. If you have not defined any
new PINS, PIN “000001” is valid for cost centre 1 and PIN
“000002” for cost centre 2.
Enter your PIN. Acknowledge this by pressing ENTER. A wrong
PIN will be rejected and you must try again.
4.3.2. Selecting postal product via OneTouch function
Your Frama Matrix F2 has a sophisticated control system, i.e. the OneTouch keys. This means that
details of postal rates do not have to be entered. Instead, each postal product is pre-selected
Your Frama Matrix F2 has been preprogrammed with the 18
most important postal products which can be fetched by
touching the OneTouch keys.
The respective postal products are written on the OneTouch
keys. The type of mailing and the destination are defined in
the first line. The weight class is shown in the second line. By
pressing the shown amount (Example here: 0.34) you can fetch further pages with predefined
products.
Each one of these so-called OneTouch keys can be redefined to suit your needs (see chapter 4.5.1).
You can fetch further product pages with the OneTouch capability by touching the postage value:
Products 1 - 6 Products 7 – 12 Products 13 – 18 1–10 Numeric keypad Postal rate guide
Owing to the key size, abbreviations are used for the postal products.
NOTE!
Your Frama Matrix F2 protects you from inadvertently franking high postal rates. As a standard
procedure, all mail items which are franked in excess of £10.00 must be released by touching the
displayed postage amount (it is first shown inverted).
All screens shown in this chapter are for reference only and may differ from
your local presentation.