Operation Manual

Frama Matrix F12

2.2.1. Make

communications connection (communications module)

e connection of the relevant cable differs depending on the communications module used.

Ethernet (green)

: Plug the network cable (RJ45) into this socket. Plug the network cable into your net-

work.

2.2.2. Connecting the scales (optional)

Plug

the scales cable into the scales socket. Look in the operating manual for the scales if necessary.

2.3. Connecting to the mains electric supply

Danger

1. Check the franking system for external damage before setting it up. You may be putting your

life at risk by using a damaged machine.

2. Check the cable and plug before installing the system. Have any damage repaired by a specialist

electrician only. Do not use the system until the damage has been repaired.

3. A damaged connecting lead may only be replaced by a lead of the same type.

4. Only connect the plug into a mains socket when the franking machine housing is closed.

5. Always run the mains cable away from the rear of the franking system and make sure that no

risk exists of it being damaged or someone tripping over it.

6. Never pull the plug out of the socket by the mains cable.

Take th

e power supply unit.

Then connect the cable with the small right-angled round plug to the Frama Ma-

trix F12 (see photograph).

Make sure that the plug clicks into place properly. This will be the case when the

cable is flush against the housing.

Make sure that you have closed the top flap on the Frama Matrix F12. Check

whether the scales are free to move.

Information

Information: The switch-on routines may take some time. During this time, the Frama Matrix F12

franking system will not accept any input from you.

2.4. First use

Insert the power supply unit into a suitable mains socket. You will hear various sounds during the switch-

on routines. All the motors and sensors are being checked.

Information

Information: The switch-on routines may take some time. During this time, the Frama Matrix F12

franking system will not accept any input from you.

e franking system must now be installed (registered) with the FramaOnline2 data centre.