Operation Manual
Frama Matrix F10 / F12
7
1. System presentation
1.1. Safety instructions/Notes on use
Danger
1. Use this franking system indoors and for franking post and franking labels only. Any other
use, modification or change to the franking system is not permissible and may be
dangerous. The manufacturer accepts no liability for damage caused by use contrary to
the intended use or incorrect operation.
2. Check the franking system for external damage before setting it up. You may be putting
your life at risk by using a damaged machine.
3. A damaged connecting lead may only be replaced by a lead of the same type.
4. A current overload protector must always be fitted in buildings in which the franking
system is plugged into the mains network.
5. Check the cable and plug before installing the system. Have any damage repaired by a
specialist electrician only.
6. Only connect the plug into a mains socket when the franking machine housing is closed.
7. Always run the mains cable away from the rear of the franking machine and make sure that
no risk exists of it being damaged or someone tripping over it.
8. Never pull the plug out of the socket by the mains cable.
9. Never reach into the printing unit. Your fingers could be injured if the franking machine is
switched on. Be careful if you are wearing long hair, a tie, etc.
10. Do not reach into rotating parts. There is a risk of injury.
11. Keep children away from the franking system.
12. Have your franking system repaired by a service technician from your local Frama sales
and service organisation only. Never open the franking system yourself under any
circumstances. Repairs carried out incorrectly can represent a significant hazard to the
user.
1.1.1. Correct use
Danger
1. Use accessories intended for this system only. The use of accessories that are not ap-
proved, or not authorised, can be detrimental to the service life of the franking system. At
the same time, a danger to the operator can be created.
2. Always keep your fingers and other parts of the body, ties, necklaces, scarves, open
sleeves and similar loose things away from the feed entry area and the rollers. There is a
risk of injury on rotating parts.
3. Do not clean the system with flammable fluids. There is a risk of explosion.
4. Disconnect the system from the mains before cleaning it. Clean the system with a damp
cloth only. Do not spray any liquids on or into the franking system. There is a risk of
electric shock. Lethal hazard.
5. Do not place any liquids, glasses, franking ink, etc. on the franking system.
1.1.2. Installation notes
Information
Your Frama Matrix F10 / F12 franking system was manufactured for use in normal conditions.
Please remember: Today’s furniture is coated with a confusing variety of paints, lacquers and
synthetic materials. In view of this, it is quite possible that some of these materials contain
constituents which can attack or soften the plastic feet of our equipment. The feet of our
equipment, if affected by foreign substances, can stain your furniture. Frama is unable to ac-
cept any liability in this respect for obvious reasons. With this in mind, use a non-slip underlay.
Avoid exposing directly to sunlight.