Operation Manual

Frama Matrix F10 / F12
42
8. Admin mode
Settings made in Admin mode always apply to all cost centres. In Admin mode you also have ac-
cess to all cost centres and can thus conveniently make settings for these cost centres (counter
readings, name and PIN). The additional features demanded by Admin mode are described below
(see section 7.1. Setup 1 menu (CC and Admin) on page 39 there are for instructions on calling up
Admin mode).
Tip
You can also make settings in each cost centre. However, when you do this not all the Admin
mode functions is available to you.
8.1. Main Menu
You are taken to the Main Menu after logging in. Franking is not possible in Admin mode. The Ad-
min functions in the Main Menu are described below.
8.1.1. Devices
8.1.1.1. Scales (optional)
There are no special features in Admin mode.
8.1.2. Logo
Specify the logo setting system-wide (to do this, in the Setup 3 menu, activate the Logo: System
function).
The other functions in the Logo menu do not differ from the descriptions from page 29.
8.1.3. Info Print
A list of all the cost centres can be printed out using the
Report CC key in Admin mode. All other reports and print
options correspond to the descriptions given earlier in
this operating manual (see section 5.5. Info Print from
page 34).
8.1.4. Printer settings
The Printer Settings menu item does not offer any additional functions in the Admin menu.
Tip
Only those settings that you have defined as SYSTEM in the Setup 3 menu, such as the logo,
can be adjusted.