Operation Manual

Frama Matrix F10 / F12

Press the Nozzle Test key and insert an envelope

or similar into the system.

A test franking mark is made. Check whether all

lines have printed. Run nozzle cleaning if neces-

sary.

5.6.2. Nozzle cleaning

White lines in the print mark or lines missing from the nozzle test print mean that the print head

must be cleaned to restore the print quality.

Information

Blocked nozzles are often the result of the electric supply being disconnected before the noz-

zles could be properly sealed. Always use the system shut-down function to switch off your

franking system reliably.

Two cleaning programmes are available to you for cleaning the nozzles:

Nozzle cleaning: A normal print head cleaning operation is run. The print head and the nozzles are

cleaned.

Thorough cleaning of nozzles: Intense rinsing and cleaning of the nozzles and print head.

To call up the required program, press the corresponding button. The cleaning program starts au-

tomatically. It is recommended that afterwards you perform the "Nozzle test" function to check that

the cleaning was successful.