Operation Manual

Frama Matrix F10 / F12

Example of a test print:

Alignment X is shown on the left and

Alignment Y on the right. Valid

alignments are indicated by an arrow.

The arrows should point to where the

lines appear straightest.

If this is already the case, you only need to confirm the following displays X and Y by pressing the

ENTER key. Sometimes, however, it is necessary for you to change the setting to optimize the re-

sults. Simply carry out the additional instructions.

This is how you should proceed: Look for the line that

appears to be straightest in the Alignment X area to the

left of the test mark. Note the number beneath it, e.g. -1.

Use the + and - keys to select the right number in the

display and then press ENTER to go to the Y setting.

Again use the + and - keys to select the right number in

the display and then press ENTER.

Run a test print again when prompted to check your settings. The arrows will now point exactly to

the settings you made, i.e. right where the lines should be straightest.

If you are still not satisfied, you can reset again by answering the prompt with NO. Press YES to save

the alignment setting.