Operation Manual

Frama Matrix F10 / F12

4.3. Determining postage value

Tip

Your franking system protects you against unintentionally franking at high postage rates (see

Settings section). By default, all franking valued over £10.00 must be approved by touching

the postage value displayed (it is initially displayed inverted). This value can be changed in

Setup 2 (section 7.2. Setup 2 menu on page 40).

Various start menus are available to you for efficient franking. You can set your preferred start menu

in Setup 1. The default menu is OneTouch.

4.3.1. OneTouch start menu

It is not necessary to enter postage values if you use the

OneTouch keys. Instead, the mail product concerned is

selected by pressing a key. Your Frama Matrix F10 / F12

franking system has already been pre-programmed with

the most important mail products.

The respective postal products are written on the

OneTouch keys. The type of mailing and the format are

defined in the first line. The destination and the weight

are shown in the second line. Pressing the display allows you to call up additional screens with pre-

defined products.

Each one of these so-called OneTouch keys can be reprogrammed to suit your needs. You can call

up further product screens with the OneTouch capability by touching the postage value:

Products 1 - 6 Products 7 – 12 Products 13 – 18 Postal rate guide

This means that you have all information clearly summarised on one key.

4.3.2 Detail-guided start menu

If you press an already selected OneTouch key again, you

can modify specific features of the postal product stored

in the system.

Each postal product is made up of features predefined by

the postal system. These are:

- Product

- Destination

- Format

- Weight

- Additional services

Press the product key and select the new product. Caution! Additional services also need to be

confirmed by pressing the OK key.

You can save your changes to the OneTouch key at any time (1-T function), or return to the

OneTouch menu by pressing Esc.

The postage will be recalculated, and you can frank the mail once the Ready prompt appears.