Operation Manual

Frama F-Link
16
3.4 Proxy Settings
When F-Link is forced to use a proxy server without authentication then set the proxy method to “Proxy
Without Authentication“. Enter the IP address of the proxy server into the field “Proxy Host”. Enter the
port number of the proxy server into the field “Proxy Port”.
When F-Link is forced to use a proxy server with authentication then set the proxy method to “Proxy With
Basic Authentication“. Enter the IP address of the proxy server into the field “Proxy Host”. Enter the port
number of the proxy server into the field “Proxy Port”. Enter the proxy username into the field “Proxy
User” and the proxy user password into the field “Proxy Password”.
Consider also chapter 4.4.
Frama F-Link
17
3.5 Configuration Page Wireless Settings
Enable or disable the wireless function over the configuration page Wireless Settings.
3.6 Configuration Page Site Survey
When the wireless function is enabled you may scan for access points using the configuration page Site
Survey.
The value RRSI show the signal level of the wireless network. If this value is too low, no stable network
connection is possible. Try to find a better position for F-Link where the signal level is higher.
When you have selected a wireless network and have pressed the button Next the additional
configuration page for the wireless network will be shown.
Select the right channel, security mode and encryption type for your wireless network. Normally you must
only enter the pass phrase or security key for your wireless network here. The other settings should be left
to the automatically detected values.