Manualshelf

Operation Manual

ManualsBrandsFrama ManualsFrankingF-Link
12345678910
Frama F-Link
10
8. Press button “Wireless ON” -> Please wait. The wireless function will be enabled.
(The execution of the command may need to be confirmed in the internet web browser)
9. Wait until Ready LED of the F-Link is switched on again. Wait until home site is displayed again.
Open configuration page Site Survey
10. Press button “Scan AP”
11. Select the wireless network which shall be used. Press button “Next”.
If your wireless network uses Hidden-SSID then press button “Next” without selecting a wireless
network.
12. Select the channel, security mode and encryption type for your wireless network. Insert the pass-
phrase / security keys for your wireless network.
Insert also the SSID of your wireless network even if it uses Hidden-SSID.
Frama F-Link
11
13. Press button “Apply”. -> Please wait. The wireless network will be connected.
(The execution of the command may need to be confirmed in the internet web browser)
14. Wait until Ready LED of the F-Link is switched on again.
15. When F-Link is able to build-up a wireless connection to your access point, the connection over
the LAN port will be closed. The F-Link configuration page can therefore not be opened again by
default IP 192.168.1.200 and a direct LAN cable connection.
If the configuration page was reloaded in your internet web browser with the default IP
192.168.1.200 the F-Link has no access to your wireless network.
Check the wireless signal strength at the F-Link position and the wireless settings of F-Link (SSID,
pass phrase, key, channel, …)
16. Disconnect direct LAN network cable between F-Link and PC.
17. Set the LAN network settings of the PC back to the previous values.
18. Execute business processes on the franking system.
Optional additional steps:
19. The F-Link configuration page can now only opened by an access via wireless network and the as-
signed DHCP IP address for F-Link. For identifying the DHCP IP address of the F-Link see chapter
2.1.3.
20. Open internet web browser on a PC that is also connected to the same wireless network as the F-
Link. Enter the DHCP IP address of F-Link into the address field of the internet web browser.