Product Overview

ManualsBrandsFPPI ManualsAccessories1-1/2" NST Cap With Chain (Rough Brass)

Speciﬁcations

Material:

B124 Brass

Size:

2½” FNST

†††

FBCT/FNYCORP

FRCH

FNYFD

FBCT

FCF

FQST

FONT

FPHX

FTEM

FCLV

FDET

1½” FNST

†††

1½” FNPSH

††

3” FNST

†

Finish:

Rough Brass

†

Also available in forged

aluminum.

††

Also available in polished

chrome or forged aluminum.

†††

Also available in ABS Plastic,

polished chrome or forged

aluminum.

Description

FPPI’s Brass caps feature all cast or forged construction of B124 brass alloy

and is complete with a gasket. Each cap is accurately machined and will provide

years of service. Our pin lug design is compatible with all re service pin lug

hydrant wrenches. Each cap is shipped complete with a brass chain and “S’

type hook for attachment to hydrant or hose type valve equipped for this use.

Protects male threads and discourages the introduction of debris into the

hydrant or valve. Suitable for re protection or industrial use.

Installation

Each cap is easily threaded in a clockwise fashion onto the male thread. Prior to

installation of the cap make sure the male threads are clean and free of debris and

the water way being covered is clean and clear of debris. Tighten using two pin

lug type hydrant wrenches. Tested to a maximum working pressure of 300 PSI.

The information contained herein is produced in good faith and is believed to be reliable but is provided for guidance and

information purposes only. FPPI and its agents cannot assume liability or responsibility for results obtained in the use or

misuse of its product by persons whose methods and qualications are outside and beyond our control. It is the user’s

responsibility to determine the suitability of, methods of use, preparation prior to use, and appropriate installation for

all products purchased from FPPI. It is the user’s sole responsibility to observe and adapt such precautions as may be

advisable or necessary for the protection of personnel and property in the handling and use of any of our products.

WWW.FPPI.COM

Brass Cap

3198 LIONSHEAD AVE

CARLSBAD, CA 92010

+ 1 (760) 599-1168

+ 1 (800) 344-1822

+ 1 (800) 344-3775 FAX

Summary of content (1 pages)

PAGE 1
Brass Cap Description FPPI’s Brass caps feature all cast or forged construction of B124 brass alloy and is complete with a gasket. Each cap is accurately machined and will provide years of service. Our pin lug design is compatible with all fire service pin lug hydrant wrenches. Each cap is shipped complete with a brass chain and “S’ type hook for attachment to hydrant or hose type valve equipped for this use. Protects male threads and discourages the introduction of debris into the hydrant or valve.