Palapala a ka mea nona

Prior to Azimuth Measurement Procedure:
Mount your phono cartridge with appropriate screws and
attach the 4 lead wires, observing proper color connection.
Right channel is red plus+ and green minus-. Left channel
is white plus+ and blue minus-. Set the Vertical Tracking
Force (VTF) per your cartridge manufacturer’s instructions.
Align your cartridge (overhang & offset for a radial arm,
tangency for a linear arm) and recheck the VTF. Next,
set the Vertical Tracking Angle (VTA/SRA) and anti-skate
per your cartridge and tonearm specifications.
FOZGOMETER V2 Power:
Connect the supplied outboard power supply to the
FOZGOMETER V2 and plug into an AC power socket.
You will need a plug adaptor for non-UL sockets. To
switch to battery operation, open the unit, removing
the four large Phillips head screws in the faceplate.
Disconnect the internal connector and install the
supplied 9-volt battery. Close the unit and reinstall the
4 screws. Please note you can only use AC or battery
power based on internal configuration.
FOZGOMETER V2 Connection:
Connect your tonearm cable left and right RCA
connectors to the corresponding left and right input jacks
on the FOZGOMETER V2. You can also connect the
FOZGOMETER V2 to the output of your phono preamp
and when using an optical cartridge with equalizer.
Analogue Productions Test LP:
Use the Analogue Productions Test LP #AAPT1,
available from your Fozgometer dealer, for azimuth
calibration. The following instructions detail using the
FOZGOMETER V2 with Side 1, track 1 for channel
balance, and Side 1, tracks 2 & 3 for channel separation.