User Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 1 Using This Manual
- 2 Introductions
- 3 Getting Started
- 4.Vehicle Identification
- 5 Diagnostic Operations
- 6 Maintenance
- 6.1 Oil Service Reset
- 6.2 Electronic Parking Brake
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 7 OBDII/EOBD Operations
- 8 System Setup
- 9 Update
23
NT6X4Elite Series User’s Manual_English_V1.02
Freeze Frame Data: a snapshot of critical vehicle operating conditions automatically recorded
by the on-board computer at the time of the DTC set. It is a good function to help determine what
caused the fault.
4. Use left and right arrow keys to scroll back and forth through different screens of data.
5. Press function key Save to store freeze frame information. Or use the BACK key to exit.
5.2.3 Clear Codes
Clear Codes menu lets you to clear all current and stored DTCs from a selected control module. Also
it erases all temporary ECU information, including freeze frame. So make sure that the selected
system is completely checked and serviced by technicians and no vital information will be lost before
clearing codes.
NOTE
●
To clear codes, make sure that the ignition key is switched to ON with the engine off.
● Clear Codes does not fix the problem that caused the fault! DTCs should only be erased after
correcting the condition(s) that caused them.
To clear codes:
1. Scroll with the arrow keys to highlight Clear Codes from Function Menu and press the ENTER key.
Figure 5-13 Sample Function Menu Screen
2. Follow the on-screen instructions and answer questions about the vehicle being tested to complete
the procedure.
Figure 5-14 Sample Clear Codes Screen