User Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 1 Using This Manual
- 2 Introductions
- 3 Getting Started
- 4.Vehicle Identification
- 5 Diagnostic Operations
- 6 Maintenance
- 6.1 Oil Service Reset
- 6.2 Electronic Parking Brake
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 7 OBDII/EOBD Operations
- 8 System Setup
- 9 Update
19
NT6X4Elite Series User’s Manual_English_V1.02
Figure 5-3 Sample Quick Scan Screen
4. If there is diagnostic trouble code(s) detected in a control unit, press the function key corresponding
with Report on the screen to view details of code information. Or press the function key Erase to
clear them.
Figure 5-4 Sample DTC Screen
5. Press function key F1 to save the trouble code information.
6. Select the system you would like to test, and press the ENTER key. When the scanner has
established connection with the vehicle, the Function Menu displays.
Figure 5-5 Function Menu screen
5.1.2 Control Modules
Control Modules screen displays all controllers available on the vehicles. The controllers listed on
the menu do not mean that they are installed on the vehicle.
To select a system for testing:
1. Scroll with the arrow keys to highlight Control Modules from the menu and press the ENTER key.
A controller menu displays.