Safety Instructions
Table Of Contents
Basic
19
Basic
Demo timer
The demo timer can demonstrate time on the screen, to better control the time during
demonstration. Please use this function as follows:
• Select the timer interval and press ◄/► to confirm the last period. The last period can be set as 1
– 5 min and the increase rates are 1min; it can also be set as 5 – 240min, including 5, 10, 15, 20,
60, 120 and 240min.
Once the timer is activated, it will be reactivated at the interval of reset timer.
• Press ▼ to select timer display and then press ◄/► to display or hide the screen timer.
Select Introduction
Permanent display Show timer of demonstration time on screen
1min/2min/3min Display timer on the screen at the final 1/2/3 min
No display permanently Hide timer of demonstration time
• Press ▼ to select timer position and then press ◄/► to set the timer position.
Upper right corner → Lower right corner →Upper left corner → Lower left corner
• Press ▼ to select timer counting method and then press ◄/► to set the required counting
method.
Select Introduction
Positive counting Increase from 0 to the set time
Countdown Decrease from the set time to 0
Press ▼, select “Start counting”, then press ◄/► and select “Yes” to enable the demonstration
timer. The timer will start counting when OSD menu is quitted.
The timer can be quitted as follows:
1. Enter basic/demonstration timer menu.
2. Press ▼ and select “Start counting”.
3. Press “No”, quit OSD menu and the timer will stop counting.