Safety Instructions

Display
16
Rim angle adjustment
1. The screen displays the OSD of 4 rim angle adjustment.
2. Select the to-be-adjusted rim angle and the selected area will become red.
3. Two angles can be adjusted.
4. Save the settings and then close OSD menu.
How to reset rim edge adjustment:
•Press “Enter” for 2s to reset. The screen will display “Reset claim: Are you sure to reset?
Yes/Cancel”.
•Rim edge adjustment will be reset if “keystone correction” is adjusted.
• Rim edge adjustment applies to Type FHD only.
Position
Display position adjustment page. This function applies only if Type PC input signal is selected.
Move the projected image though the direction arrow key. When the key is pressed, the values
displayed at the bottom half of page will also change, until it reaches the max. or the min. value.
Phase position
Adjust the clock phase position to reduce the image deformation. This function applies only if
Type PC input signal is selected.
Horizontal dimensions
Adjust the horizontal width of image. This function applies only if Type PC input signal is
selected.
Zoom
Adjust this item to zoom in or out the picture.
Overscanning
Close 1/2/3/4/5
Overscanning is used for expanding the image by 5% or even 10%, extend the distorted image
outside the screen size and show the good-linearity section of middle parts, to avoid distorted
images at the screen rim.