Safety Instructions

Power on/off Projector
6
Power on/off Projector
Power on projector
Turn on the projector
1. Finish the wiring of AC power line and signal line of peripheral equipment.
2. Press button on control panel or “POWER” button on remote controller to power on the
Product.
3. Power on the signal source (computer, laptop, DVD, etc.) to connect the extenral signal
sources. The Product will have auto detection of signal sources. Press “Source” button if the
Product has connection to multiple signal sources simultaneously.
Power on: The power standby button is normally on in red;
Startup process: Press the “Power” key and standby button will flicker between red and blue;
Startup: The power standby indicator is normally on in blue;
Shutdown: When the Product is shut down, the power standby button and indicator will
flicker at the same time and enter shutdown status.
Warning
•Do not stair at the lens when laser point is on; otherwise, your eyes will be damaged!
•Do not place any object near the air outlet to avoid fire hazards, for it is very hot.
Power off projector
1. Double click to start shutdown of computer and then the Product will shut down.
•The cooling fan will keep rotating until the cooling process is completed.
•Power LED starts flickering and the Product will enter standby mode.
•Make sure the Product is cooled and enters standby mode before powering on it again. Once
standby mode is entered, press to restart the Product.
2. Unplug the AC power line from the power socket and the Product respectively.
3. Do not power off the Product directly during shutdown.