User's Manual

times, we recommend using high capacity 2000-2800 mAh NiMH (Nickel Metal
Hydride) rechargeable cells rather than alkaline types.
When you operate your FURY to play at extremely loud volume levels, the
current demand on the batteries is much more than alkaline cells can deliver.
Consequently, the run time of these batteries can be very short. The Zinc
Carbon so-called “Heavy Duty” cells are expressly NOT recommended at all.
The performance of your FURY will be much better with high capacity
NiMH batteries.
3.1 INSTALLING BATTERIES IN THE FURY:
1) Remove the battery door. The battery door is located on the side of
the caller and is held in place with a knurled thumbscrew.
2) Orient the batteries as per the directions shown in each cavity within
the holder. Note that the battery polarity alternates.
3) Replace the battery door after the batteries are installed.
CAUTION: Never attempt to charge batteries not intended to be
recharged! This includes both Zinc Carbon and alkaline cells. The resulting
damage can be serious and will not be covered by the warranty. For maximum
charge efficiency, we recommend charging your FURY in temperatures ranging
from 40°F to 85°F (5°C to 30°C).
CAUTION: Do not mix battery types!
CAUTION: Never connect your Fury charge to a 12V automotive system.
Serious damage will occur which is not covered by the warranty. The charge
jack is intended only for FOXPRO chargers.
CAUTION: Never attach an unapproved or non-FOXPRO charger to your
Fury! Damages caused be plugging unapproved charging devices into your
Fury will not be covered by warranty.
3.2 CHARGING BATTERIES
1) Disconnect any accessory device that may be plugged into the Fury
prior to charging. This includes external speakers, USB cables, and
any devices that may be attached to the auxiliary device jack.
2) Check to make sure that rechargeable NIMH type batteries are
installed in your FURY.
3) Connect the approved FOXPRO charger to the FURY charge jack and