User's Manual

2) Enter your “MY COMPUTER” icon and locate the FURY from the list of
available drive letters. Once you have located the drive for the FURY,
double-click on the icon to open it up.
3) After the drive is opened, locate the file named labelutil.exe and then refer
to steps 6 through 9 for installation of the Programming Utility.
8.3 PROGRAMMING WITH THE UTILITY
To gain access to the Fury’s USB port
1) Remove the battery compartment door from the back side of the Fury and
remove the batteries. The USB port will be accessible through the bottom of
the battery compartment.
2) Connect the provided USB cable between this port, and the USB port on
your computer. Once the connection is made, your computer should
recognize the FURY as a removable drive.
Programming Process
1) Double click the folder on your desktop or go to your programs folder and
open the FOXPRO Programmer. You will be prompted to make a backup of
your sounds.
2) Select OK, you will then be taken to the programming utility.
3) Select the proper USB drive for the FURY. This is marked as Select
Device, located in the upper right portion of the programming utility.
NOTE: This drive varies on different computers. Once you have
selected the drive, the list of sounds currently on your FURY appears
in the right vertical window. You will now notice that a new button
appears above the Select Device window that reads “Backup”. If you
have not made a backup of your sounds, simply click on this button.
The programmer by default will backup your sounds to a “FOXPRO”
folder, and a sub folder “Backup”. This is also a good folder to use to
add new sounds prior to adding sounds, or reprogramming your
FURY. You can also create sub folders for different species, if you
choose, rather than to have all sounds located in one folder. Once
your backup is complete, you are ready to reprogram your FURY.
4) Select the “source” folder of your new sounds (Located on the left hand
side of the programmer screen). This is the folder where your sounds are
located.
5) Double click on the C:\ prompt, and locate the “FOXPRO” folder. The
sounds sub folder should show up, assuming that you have used this folder