User's Manual

FOXFADE in Stereo Mode
When you are operating the Fury in stereo playback mode and playing a stereo
audio file, the left audio channel will play through the front horn speaker and the
right audio channel will play through the back cone speaker. Let’s say that the
sound you are playing is a coyote and rabbit stereo file; coyote on the left
channel and rabbit on the right channel. When you enter FOXFADE and move
the vertical bar towards the left and lock the selection in, the sound of the rabbit
on the right channel will be reduced. If you move the bar to the right and lock
the selection in, the sound of the coyote will be reduced.
FOXFADE can help create many new scenarios in the field and help add
realism to your stand.
Using a Mono File in Stereo Mode
If you are playing a mono file while operating the unit in stereo mode, the Fury
will play the same sound out of both speakers. FOXFADE will act in the same
manner as playing a stereo file with fading out the volume of one of the
channels depending upon which way you move the bar.
6.10 AUTO-V
AUTO-V (auto-volume) provides you with a sort of “cruise control” for volume
adjustment and attenuation. When engaged, AUTO-V will start at the lowest
possible volume (0) and slowly climbs to 75% or volume level 30 which is the
default maximum volume level for AUTO-V, across a three minute period. Once
volume level 30 is reached, AUTO-V begins to reduce and increase the volume
level by 30% increments every ten seconds. For example, volume level 30 will
be reduced by 30% in a ten second period, and then increased back up 30%
across another ten second period. It will continue operating in this manner until
it is shut off.
AUTO-V will not work in preset or sequence modes. Please see the sequence
section if you are interested in learning how to automatically ramp the volume
of sounds in your particular sequence.
Turning AUTO-V On
It is not necessary that you have a sound playing prior to engaging AUTO-V as
it will begin its cycle after the sound begins playback.
1) Hold down the selector knob for 2-3 seconds to access the main menu.
2) Select “CALLER CONFIG
3) Select “AUTO-V ON” to engage AUTO-V