User's Manual

Page | 26
recognize the SNOW-CROW PRO 2 as a removable drive.
Programming Process
1. Double click the folder on your desktop or go to your programs folder
and open the FOXPRO
®
Programmer. You will be prompted to make a
backup of your sounds.
2. Select OK, you will then be taken to the programming utility.
3. Select the proper USB drive for the SNOW-CROW PRO 2. This is
marked as Select Device, located in the upper right portion of the
programming utility.
NOTE: This drive varies on different computers. Once you have selected the
drive, the list of sounds currently on your SNOW-CROW PRO 2 appears in
the right vertical window. You will now notice that a new button appears
above the Select Device window that reads “Backup”. If you have not made
a backup of your sounds, simply click on this button. The programmer by
default will backup your sounds to a “FOXPRO
®
” folder, and a sub folder
“Backup”. This is also a good folder to use to add new sounds prior to
adding sounds, or reprogramming your SNOW-CROW PRO 2. You can also
create sub folders for different species, if you choose, rather than to have all
sounds located in one folder. Once your backup is complete, you are ready
to reprogram your SNOW-CROW PRO 2.
4. Select the “source” folder of your new sounds (Located on the left hand
side of the programmer screen). This is the folder where your sounds
are located.
5. Double click on the C:\ prompt, and locate the “FOXPRO
®
” folder. The
sounds sub folder should show up, assuming that you have used this
folder to store your sounds. If this is not the folder that your sounds are
located in, select the proper folder.
6. Once the proper folder is selected, double click the folder. The sounds
should now appear in the left side column, called “Source Sound Files”.
Now, determine the position that you would like to add new sounds to your
SNOW-CROW PRO 2. For example, if you would like to add the Jackrabbit
Distress to your SNOW-CROW PRO 2, highlight the sound in the left side
column.
NOTE: If this sound does not have a three digit number and a space located
at the beginning of it, you must check the Append Sound Number box
located below the left column. By selecting this box, the sound name will not
be shortened. If there is a three digit number and a space before the name
of the sound, there is no need to check this box. The first four characters will
be either truncated or ignored, by not selecting this box.