User's Manual

Page | 25

3. Locate and click on “FOXPRO

Programming Utility”

4. Click on “Download Now”

5. Click on the Save button to save the executable file to your hard drive

for installation. If you choose to save the file to your hard drive, we

recommend saving it to your desktop.

NOTE: When saving the file, the name of the file on your Desktop (if you

choose your desktop as the location to save) will be labelutil.exe.

6. Double click the labelutil.exe icon, and select Run. The installation

process will now begin.

7. At the next screen, select OK.

8. Click on the button where prompted (the button is the one that

resembles a computer).

9. Click on the continue button. This should complete the setup of the

FOXPRO

Programming Utility

NOTE: The icon on your desktop is only an .exe file used to install the

programming utility to your computer. Once you have completed the

installation of the program, this icon can be deleted. The actual program will

be in your program files on your computer, and is called FOXPRO

Programmer.

The Programming Utility is also stored on the SNOW-CROW PRO 2 memory

card.

To download and install the Utility from your SNOW-CROW PRO 2

1. Connect your SNOW-CROW PRO 2 to your PC with a standard USB

cable (type A/B). Once the SNOW-CROW PRO 2 is recognized by the

PC it will be assigned a drive letter.

2. Enter your “MY COMPUTER” icon and locate the SNOW-CROW PRO

2 from the list of available drive letters. Once you have located the drive

for the SNOW-CROW PRO 2, double-click on the icon to open it up.

3. After the drive is opened, locate the file named labelutil.exe and then

refer to steps 6 through 9 for installation of the Programming Utility.

7.3 PROGRAMMING WITH THE UTILITY

To gain access to the SNOW-CROW PRO 2’s USB port

1. Open the latches on the front of the SNOW-CROW PRO. The USB port

is accessible towards the middle of the main panel. It is clearly labeled

USB.

2. Connect a USB cable between this port, and the USB port on your

computer. Once the connection is made, your computer should