User's Manual
Page | 15
Set volume to 30
Play sound 12 one time
Pause for 60 seconds
Set volume to 23
Play sound 1 one time
End
The above example uses the following syntax to denote instructions for the
SNOW-CROW PRO 2. All possible commands are shown below:
Instruction Value Description
S 0 – 499 Denotes numerical value of sound on unit
V 0 – 40 Denotes numerical value of volume level
P 1 - 99999 Denotes delay value in seconds (approx.)
J n/a Denotes Jukebox Mode
R n/a Denotes Repeat Mode
Q n/a Denotes Single Play Mode
Any time you author your own sequence file manually, make certain that each
instruction code is followed by a space and then the value.
Note: Each file must begin with a P or V value—if you start the sequence with a
sound, the SNOW-CROW PRO 2 will not know at what volume level to play the
sound.
Also make sure that you end the instructions with a capital J, R, or Q. If you end
the file with J, the SNOW-CROW PRO 2 will move on to the next available
sequence. If the file ends with R, the SNOW-CROW PRO 2 will repeat the
current sequence. Ending the file with a Q will result in the sequence playing
one time.
If you desire to have a sound play more than one loop, you will need to have
the sound listed as many times as you wish it to play. Example:
V 10
S 16
S 16
S 16
V 15
S 16
Q
This example shows that the volume is set to 10 for three loops playing sound