User's Manual

attach the transformer end of the charger to the appropriate outlet.
Be aware that the green LED may or may not extinguish when the
batteries are fully charged. Your FOXPRO unit incorporates circuitry to
terminate charge current if high battery temperatures are detected. Battery
temperatures increase at the end of the charge cycle. If the temperature edges
towards a dangerous level, the charge current will be interrupted and the green
LED will extinguish. If excessive temperature is not detected, the green LED
will not be extinguished. It is quite possible for the batteries to be fully charged
without their temperature rising to the dangerous level. For this reason, the
LED should not be considered as a “full charge” indicator as it may or may
not extinguish when the batteries are fully charged. The batteries are fully
charged any time their temperature rises substantially above ambient. How
long this takes depends on how much charge has been taken from the
batteries and how much time has passed since the last charge. If the green
LED goes out, the batteries are definitely charged. If the green LED is on and
the batteries are cool, they are still charging. If the green LED is on and the
batteries are very warm, they are fully charged and you should terminate the
charge by unplugging the charger.
You should not permit the charge to continue for more than 12 hours
under any circumstances. The batteries need to be recharged when the “Low
Battery” LED is blinking. Battery run time is directly related to how loud you
operate the FURY. Using both speakers at the same time rather than only the
most appropriate one will have a negative impact on run time. With one
speaker playing, expect 6 to 15 hours of run time, depending on the loudness
setting. With both speakers playing, expect 3 to 10 hours. Remember that very
loud volumes are rarely needed as animals hear much better than we do.
Battery/Charging Recommendations
• Remember that NiMH batteries self-discharge about 1% per day
• Do not charge batteries unattended
• Remove batteries from battery holder when caller will not be used for
prolonged periods to help prevent deep discharge
• Recharge your batteries periodically—even when not in use—to
prevent deep discharge
4.0 “AUX” JACK FUNCTION
The FURY is equipped with an auxiliary jack labeled “AUX”. The purpose of this
jack is to allow for the connection of certain external devices, such as the
FOXPRO Jack-in-the-Box Decoy or other approved devices, and to be able to
turn these on and off with the TX-500 remote control transmitter. However,