User's Manual

sound in the sequence or last sequence played, rather it will go back
to the last regular sound that was played.
6.8 SOUND PRESETS
The TX-500 provides you with quick access to your favorite sounds and
volumes with the push of a button. The TX-500 can hold a total of ten individual
sound presets, each one having their own unique volume level. You will also
find two quick-access buttons (P1 and P2) that provide you one-button access
to the sounds stored on presets one and two.
Creating Presets
1) Press the PRESET button to enter preset mode
2) Press and hold a number key from the keypad 0-9 for around 2-3
seconds. Doing this will display “SET SOUND AND VOLUME LEVEL”
on the top line of the TX-500 display.
3) Highlight the sound you wish to have set as the current preset
4) Use volume up/down buttons to set the desired volume level
5) Press the number key one last time to lock that sound in that position
6.9 FOXFADE
FOXFADE allows you to fade the volume level of the sound being played
between the front and back speaker. There are several ways in which
FOXFADE can be used; mono, stereo, and reversed stereo. FOXFADE will
provide the best effect when using a stereo audio file that contains two
separate animal recordings; however, it can be used with mono sounds that are
being played in stereo mode.
Using FOXFADE
1) With the sound playing, press the FOXFADE button on the side of the
TX-500 transmitter
2) Use the selector knob to move the vertical bar left or right on the
screen. Moving the knob clockwise will result in the bar moving
towards the left of the screen which corresponds with the front (horn)
speaker and the left audio channel. By moving the bar in this direction,
the volume level of the back speaker will go down.
Moving the knob counterclockwise will result in the bar moving
towards the right of the screen which corresponds with the back (cone)
speaker and right audio channel. By moving the bar in this direction,
the volume level of the front speaker will go down.
3) Once you have positioned the bar in your desired position, press down
the selector knob one time to lock the change in place.