User's Manual

example of what the file should look like:
V 30
S 12
D 60
V 23
S 1
X
The above example uses the following syntax to denote instructions for the
Fury:
Instruction Value Description
S 0 – 499 Denotes numerical value of sound on unit
V 0 – 40 Denotes numerical value of volume level
D 1 - 99999 Denotes delay value in seconds
J n/a Denotes Jukebox Mode
R n/a Denotes Repeat Mode
? n/a Denotes Single Play Mode
X n/a Denotes end of file
The translation of the above example would equate to:
Set volume to 30
Play sound 12 one time
Pause for 60 seconds
Set volume to 23
Play sound 1 one time
End
Any time you author your own sequence file manually, make certain that each
instruction code is followed by a space and then the value. Also make sure that
you end the instructions with a capital X.
Loading a Sound Sequence to Your Fury Manually
In order to get the sound sequence file from your computer into your Fury, you
will need to locate the USB cable provided with the unit. Remove the battery
compartment door on the Fury and remove the battery pack. Locate the USB
port in the bottom of the battery compartment. Using the USB cable, connect
the Fury to your computer. Take note to what drive letter is being assigned to
your Fury. Copy the sequence files from your hard drive directly into the drive
letter of the Fury.