User's Manual





Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or

transmitter.

/Canada market, only channel 1~11 can be operated. Selection of other channels is

IMPORTANT NOTE:

This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance

requirement of the end product, which integrates this module.

20cm minimum distance has to be able to be maintained between the antenna and the users for the host this

module is integrated into. Under such configuration, the FCC radiation exposure limits set forth for a

population/uncontrolled environment can be satisfied.

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to

operate this equipment.

USERS MANUAL OF THE END PRODUCT:

In the user’s manual of the end product, the end user has to be informed to keep at least 20cm separation with

the antenna while this end product is installed and operated. The end user has to be informed that the FCC

radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also

be informed that any changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then additional FCC

part 15.19 statement is required to be available in the user’s manual: This device complies with Part 15 of FCC

rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference

and (2) this device must accept any interference received, including interference that may cause undesired

operation.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator & you