RUGO™ 700-300 PRODUCT MANUAL
RUGO™ REFERENCE GUIDE TABLE OF CONTENTS FULL ASSEMBLY INTRODUCTION Reference Guide 3 Overview 4 Physical Characteristics 4 ¼"-20 MOUNT POWER PACK GUARDS Charging the Power Pack 5 Reassembling the Rugo after Charging 6 Power Pack Life 6 Operational Modes 6 ™ POWER/MODE SWITCH TRI-LENS™ CHARGE INDICATOR THUMBSCREWS TRI-LENS™ Using the Tri-Lens™ 7 Removing the Tri-Lens ™ 7 REMOVING/CHANGING MOUNTS Removing the Standard Mount 8 Removing the ¼"-20 & Cold-Shoe Mount 8 DISASSEMBLED LI
OVERVIEW CHARGING THE POWER PACK The Rugo™ is a compact and powerful LED Light which has the ability to be mounted to the GoPro®, a DSLR, a drone, a tripod and many other devices. Having four different intensities (70–700 Lumens) with three interchangeable lens settings (Tri-Lens™), makes it a powerful tool for action sports as well as photography and filming. A Charge Indicator and Quick Swap™ Power Pack makes the Rugo™, patents pending, one of a kind.
REASSEMBLING THE RUGO™ AFTER CHARGING 1 1. 2 2. Install the Power Pack to the Light Head—confirm position of alignment posts to their respected cavities. Push both halves together. A ‘click’ should be heard as they become locked together. USING THE TRI-LENS™ The Rugo™ Tri-Lens™ has three (3) beam emission angles which can be used for many different applications by simply sliding from left to right and vise-versa.
REMOVING/CHANGING MOUNTS MOUNTING TO DEVICES STANDARD MOUNT ACTION CAM 1 2 3 The Rugo™ can be mounted to an Action Cam via the removable Standard Mount. Line up the mounts on the Rugo™ with the mounts on the Action Cam and then tighten the Mount Knobs. NOTE: Orientation of Knobs should match as shown below. 1 1. Start with the Rugo™ positioned so that the Thumbscrews are on top. 2. 2 Twist each Thumbscrew counter-clockwise until they become loose. They should then be ready to pull out completely.
MAINTENANCE NOTES REPLACING THE O-RING (P/N 51-112) 1 2 3 O-RING RETAINING TAB 1 1. Separate the Power Pack from the Light Head (follow steps 1–2 in the “Charging the Power Pack” section on page 5). 2. 2 Using a #2 Phillips head screwdriver (not included) remove the screw from the Light Head (reference “Disassembled Light Head” diagram on page 3). 3 3. The Retaining Tab and O-Ring can now be removed. If the O-Ring does not fall out on its own when unscrewed, it may need to be pulled out.
WARRANTY AND OTHER INFORMATION PRODUCT DURABILITY 20 M IPX7 3M PRODUCT NAME: Rugo™ MODEL NUMBER: 700-300 ADAPTOR INPUT: AC 100-240V, 50/60 Hz CARE/CLEANING Your FoxFury product is a professional tool. Regular maintenance and care of your light will maximize performance for you. As needed, wash your FoxFury product using a soft washcloth, clean water and a mild soap. Be sure that both the Light Head and Power Pack are reassembled securely before washing. When done, pat dry with a damp cloth.
FOXFURY.
