Installation Instructions

13
Hardware Installation
3.4.2. Installing an Atlas Key Module
Follow these steps to install an Atlas assembly:
1. $OLJQWKHPDWLQJERDUGIRUHDFKVLGHRIWKHFKDVVLV7KHDOLJQPHQWFRQ¿JXUDWLRQLVLQYHUWHGIRU
the left and right sides.
2. Connect the cables for each mating board connector.
3. Align the mating assembly in the chassis and slide in place. Once properly installed the screw
holes on the bracket and board are aligned.
4. Insert the screws and secure the board to the chassis.
)LJXUH ,QVWDOOLQJD0DWLQJ%RDUG$VVHPEO\
5. Align the external Atlas key module with the chassis and the connector on the mating board. The
standoff on the module aligns with the chassis.
,QVHUWWKHNH\LQWKHWKHIURQWEH]HOXQWLOLWLVÀXVKLQSODFH
7. Tighten the thumb screw to secure it.
)LJXUH ,QVWDOOLQJDQ$WODV.H\0RGXOH
Replace the top cover on the server. See “Installing a Top Cover” on page 11.