Owner's Manual

Power-On Self-Test (POST). The LED is located at the front panel, and it displays POST state

by different long-short blinking intervals. You can always leave this state enabled.

► Smart Boot Menu

When PC starts, it will ask you to press [Del] key to enter setup or press [Esc] key to enter

smart boot menu. If [Disabled] is selected, then pressing [Esc] has no function.

► Current CPU Speed

This item displays the current CPU speed.

► Current DRAM Clock

This item displays the current DRAM clock, in dual DRAM controller

Fox Intelligent Stepping

► CPU Clock

This option is used to adjust the CPU clock.

► PCI Express Clock

This option is used to adjust the speed of PCI Express slot. It may enhance the graphics card

speed.

► CPU Multiplier Adjust (Optional only if CPU supports)

This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can

get the CPU speed. Increase this ratio may overclock your CPU. This option will be displayed

only if your CPU is supporting this feature.

Fox Intelligent Stepping

CPU Clock [200] Help Item

PCI Express Clock [100]

CPU Multiplier Adjust [Auto]

Spread Spectrum [Enabled]

↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help

F9:Optimized Defaults

[200]

System Status Power LED Status

Normal On

No CPU Fan Blinking once (blinking 0.5 sec., off 0.5 sec.)

No Display Blinking once (blinking 2 sec., off 2 sec.)

No Memory Blinking twice

Post Error Message Blinking thrice