User`s manual

Chapter 2 Installation Instructions
15
Front Panel Connector: FP1
(Please refer to the 18th item of motherboard layout.)
This motherboard includes one connector for con-
necting the front panel switch and LED indicators.
IDE LED Connector (HD-LED)
The connector connects to the case’s IDE indicator LED indicating the activity
status of hard disks.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PWRLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system’s status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Switch Connector (PWRSW)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
FP1
NCHD-LED
RESET
PWRLED
PWRSW
Empty
+ -
+ -
1
Fan Connectors: CPU_FAN, FAN1
(Please refer to the 5th and 13th item of motherboard layout.)
The fan speed of CPU_FAN and FAN1 can be detected and viewed in “PC
Health Status” section of the CMOS Setup. These fans will be automatically
turned off after the system enters S3, S4 and S5 mode. Plug the CPU cooling
fan cable into the CPU_FAN connector. Connect the system cooling fan cable to
FAN1 connector.
CPU_FAN
FAN1
SENSE
GROUND
1
POWERCONTROL
+12V
GROUND
SENSE
1
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn