User Manual

ASSEMBLING THE EXTENSIBLE SUPPORTS

The mitre saw is equipped with two lateral extensible supports

(A)

Fig.5

useful to support long work-pieces

during the cut. These suports can be assembled on both sides of the machine, depending on the dimensions of

the work-piece.

Unscrew the knob

(B),

insert the extensions into the slots on both sides of the base and lock the knobs again

ASSEMBLING THE DUST COLLECTOR’S BAG

insert the dust bag

(A) Fig. 6

into the slot

(B)

and verify that it is correctly assembled.

For a better dust collection, you can connect directly to the extracting elbow a vacuum dust collector .

Note

: empty regularly the bag to prevent obstructions. The bag is equipped with a zipper, for an easy cleaning.

You can wash the bag with soap warm water and dry it before reusing

Make sure that the zipper is correctly closed before cutting.

WARNING: dust particles can cause breathing problems.

For your safety we recommend to wear a protective mask, according to existing norms.

CUT-END GUIDE EXTENSIONS

The cut-end guide can be extended on both sides in case of wide work-pieces. To do this:

1. Loosen the knob (C).

2. Slide the extension (A) on the desidred position and tight the knob (C).