Wi-Fi Window/Door Sensor FS-WDS100 Quick Start Guide
What’s in the Box Wi-Fi Window/Door Sensor FS-WDS100 Quick Start Guide Wi-Fi Window/Door Sensor Quick Start Guide Screwdriver 2 AAA Batteries
Safety Instructions • Practice safe installation habits while installing the Wi-Fi Window/ Door Sensor. • Your Wi-Fi Window/Door Sensor is intended for indoor use only. • Do not tamper with or make any modifications to your Wi-Fi Window/ Door Sensor. • Make sure you replace batteries with 2 new AAA alkaline batteries. Insert batteries in the correct polarity as shown inside the battery case. • Properly dispose of old batteries in accordance with local regulations.
Wi-Fi Window/Door Sensor Installation and App Setup 1. Download the FS Home App from the App Store or Google Play. FS Home App Store is a service mark of Apple Inc. Google Play and the Google Play logo are trademarks of Google LLC. 2. Connect your smartphone or tablet to your local 2.4GHz Wi-Fi network.
3. Launch the FS Home App. 4. Sign up for an account or Login with your email or password. 5. Go to "Device" and press "+" in the upper right-hand of the screen and follow the on-screen pairing instructions. Make sure your phone is connected to a 2.4GHz Wi-Fi network Wi-Fi NAME •••••••• Important: Ensure that the network name or SSID is the desired network you want the devices to use. If it is different from your smartphone’s Wi-Fi settings, your device pairing will be unsuccessful. 6.
7. Using the provided screwdriver to remove the battery cover. Do NOT unscrew the four screws on the back of the sensor. Unscrew this screw to open 8. Scan the device QR-Code/UID with your smartphone or tablet or enter it manually. The QR-Code is located on the inside of the battery cover. QR-Code 9. Insert 2 new AAA batteries. Make sure you insert batteries in the correct polarity.
10. Press "Pair" in the FS Home App within 10 seconds of inserting the batteries. Important: When pairing is successful, a new device will be added to your Device page. If unsuccessful, repeat Step 5. 11. Install the Wi-Fi Window/Door Sensor onto the desired window or door with the included adhesive strips. Recessed Door Sliding Window Cupboard *Sensor and magnet must be less than 1/2” (12mm) apart.
Troubleshooting 1. Pairing Unsuccessful a. Make sure that your smartphone or tablet is connected to the desired Wi-Fi network. b. Make sure that the Wi-Fi network your smartphone or tablet is connected to is a 2.4GHz network, not a 5GHz network. This is only necessary when pairing. c. Make sure that the Wi-Fi signal is strong at the desired installation location. d. Unplug or power down other Wi-Fi devices to minimize wireless interference during setup. e.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
CE marking on this product represents the product is in compliance with all directives that are applicable to it. Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
QSG-WDS100EN V.03 04/2019 Fox & Summit USA, LLC | 888.606.1589 | www.foxandsummit.com © 2018 Fox & Summit USA LLC. All Rights Reserved.
