Installation Guide

4
Note: Please refer to local cable type and color for actual installation.
a. Hold the middle part of the female insert, rotate the back shell to
loosen it, and detach it from female inset.
b. Remove the cable nut (with rubber insert) from the back shell.
· Slide the cable nut,
then the back shell onto the cable.
- Trim all the wires to 52.5mm and the PE wire to 55mm.
- Use the crimping pliers to trim 12mm of insulation from all wire ends
as shown in the picture.
· Separate the AC plug into three parts as below.
L: Brown/Red Wire
N: Blue/Black Wire
PE: Yellow & Green Wire
· Push the threaded sleeve into the socket,
tighten up the cap on the terminal.