Quick Installation Guide 3-6kW Single Phase Inverter Packing List A B C D E Manual F G H I L M N J Quick Installation Guide K Object Quantity A 1 Description Inverter Object Quantity H 1 Description Earth terminal Communication connector B 1 Bracket I 1 & Unlock tool C 4 DC connector (F/M) J 1 Product manual K 1 Quick installation guide AC connector & D 1 Unlock tool E 3 Expansion tube L 1 CT (Optional) F 3 Expansion screw M 1 WiFi/LAN/GPRS(Optional) N 1
Inverter Installation Please make sure the inverter will be installed with a proper distance as shown below. Position Min Size Left 30cm Right 30cm Top 30cm Bottom 30cm Front 30cm Step 1: Fix the bracket on the wall Choose the place you want to install the inverter. Place the bracket on the wall and mark the position of the 3 holes from bracket. Drill holes with electric drill, make sure the holes are at least 50mm deep, and then tighten the expansion tubes.
Insert the expansion tubes into the holes and tighten them. Install the bracket with the expansion screws. Step 2: Match the inverter with wall bracket Hang the inverter over the bracket, slightly lower the inverter, and make sure the two mounting grooves on the back are properly fixed with the two bracket bars. Wiring Steps AC Wiring - Cable dimensions Model (kW) 3.0 3.6 4.6 5.0 5.3 6.
- Trim all the wires to 52.5mm and the PE wire to 55mm. - Use the crimping pliers to trim 12mm of insulation from all wire ends as shown in the picture. L: Brown/Red Wire N: Blue/Black Wire PE: Yellow & Green Wire Note: Please refer to local cable type and color for actual installation. · Separate the AC plug into three parts as below. a. Hold the middle part of the female insert, rotate the back shell to loosen it, and detach it from female inset. b.
· Push the threaded sleeve to connection terminal until both are locked tightly on the inverter. · Remove the AC connector, press the bayonet out of the slot with a small screwdriver or the unlock tool and pull it out, or unscrew the threaded sleeve, then pull it out. DC Wiring · Turn off the DC switch. · Choose 12 AWG wire to connect the PV module. · Trim 6mm of insulation from the wire end. · Separate the DC connector as below.
· Insert striped cable into pin contact and ensure all conductor strands are captured in the pin contact. · Crimp pin contact by using a crimping plier. Put the pin contact with striped cable into the corresponding crimping pliers and crimp the contact. ➢ · Insert pin contact through the cable nut to assemble into back of the male or female plug. When you feel or hear a “click” the pin contact assembly is seated correctly. · Unlock the DC connector - Use the specified wrench tool.
Grounding Wiring Screw the ground screw with screwdriver as shown below. Startup Procedure 1. After checking all connections are correct, turn on the external DC/AC breakers. 2. Turn the DC switch to “ON” position. 3. lnverter will start automatically when PV panels generate enough energy. The LED will be green and the LCD screen will display the main interface. Note: · When starting the inverter for the first time, the country code will be set by default to the local settings.
