Installation Instructions

6110 Abbott Drive | Omaha, NE 68110 | 877-369-2562 | WWW.FOXBLOCKS.COM
Fox Blocks ICF Guidebook V5MAR17
21
FOX BUCK INSTALLATION
INSTALLATION STEPS:
STEP 1
a) Build wall as normal with
opening 4" larger than
rough opening.
b) Ensure all opening rebar is
properly placed and secured.
c) Double check opening
measurements.
STEP 2
a) Cut sides to length and notch
each end 1" as in photo.
b) Place Fox Buck sides into place
and hold with tape.
Option: Spray foam can be used
to completely seal buck to block
STEP 3
a) Cut and place top and bottom
Fox Bucks
Option: Spray foam can be used
to completely seal buck to block
b) Penetrate all slots with a nail
or screw to ensure
entrapped air can
escape during
concrete placement.
STEP 4
Cut and remove all circles in sill.
This will ensure proper concrete
consolidation during concrete
placement.
Notes:
It is preferred to have these circles
cut out prior to placing the Fox Buck
sill in place. This will eliminate any
foam cutouts accidently falling into
wall cavity.
Holes can be cut square to allow
maximum hole size for concrete
placement.
STEP 5
Brace inside opening to hold square
during concrete placement.
STEP 6
When openings are close to a
corner, strapping is required to hold
corner in place during concrete
placement.
Temporary
support
can be
attached to
Fox Buck
fastening
zones.