Technical Specifications

6110 Abbott Drive
Omaha, NE 68110
1-877-369-2562
www.foxblocks.com
Please call toll free, 877-369-2562, or visit WWW.FOXBLOCKS.COM for more information.
© 2013 Fox Blocks
Page 2
00480 Fox Buck Tech Doc Rev-F.pdf
inStaLLinG tHE FOX BuCK
inStaLLatiOn StEpS:
StEp 1
a) Build wall as normal with
opening 4” larger than rough
opening called for.
b) Ensure all opening rebar is
properly placed and secured.
c) Double check opening
measurements.
StEp 2
a) Cut sides to length and notch
each end 1” as in photo.
b) Place Fox Buck sides into place
and hold with tape.
Option: Spray foam can be used
to completely seal buck to block
StEp 3
a) Cut and place top and bottom
Fox Bucks
Option: Spray foam can be used
to completely seal buck to block
b) Penetrate all slots with a nail
or screw to ensure
entrapped air can
escape during
concrete placement.
StEp 4
Cut and remove all circles in sill.
This will ensure proper concrete
consolidation during concrete
placement.
Note: It is preferred to have these
circles cut out prior to placing the Fox
Buck sill in place. This will eliminate
any foam cutouts accidently falling
into wall cavity.
StEp 5
Brace inside opening to hold square
during concrete placement.
StEp 6
When openings are close to a
corner, strapping is required to hold
corner in place during concrete
placement.
Temporary
support
can be
attached to
Fox Buck
fastening
zones.