Installation Instruction

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
Fig.1
PREPATION
1. Shut off the power at the fuse box or circuit breaker
box. If necessary, remove the old fixture and all
mounting hardware from junction box.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any parts
necessary for installation.
ASSEMBLING THE FIXTURE(Fig.1)
3. Thread decorative stems (L) into the main body (M).
4. Determine the desired hanging height and install
stems (G, H, I, J) onto nipple (K). Carefully pass the
wires through each rod during assembly. Remove
the nipple when assembling with only one 6’’ or 12’’
rod.
5. Loosen screws (D) (Size: #5-32*0.4”L) to separate the
canopy (C) from the mounting plate (A).
6. Slip canopy (C) over rods (G, H, I, J) and allow it to
rest on the fixture body. Thread nipple (F) into rod
(G).
7. Align glass shades (O) followed by spacers (P) over
sockets (N) and secure with socket rings (Q) via the
wrench provided (S).
MOUNTING THE FIXTURE (Fig.1)
8. Raise the mounting plate (A) to the junction box (not
provided) and secure with junction box screws (B)
(Size: #8-32*0.6”L) .
9. Install the fixture body into the mounting plate (A) by
tilting at a slight angle so that the hanger ball (E)
slips into the mounting plate (A) as shown. Align the
notch in the hanger ball (E) to the tab on the
mounting plate (A) to prevent the fixture from turning.
CONNECTING THE WIRES (Fig.2)
10. At this point, connect the electrical wires as shown
in figure 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the ground wires from the
hanger ball and mounting plate to it. Otherwise,
connect the ground wire from the hanger ball directly
to the mounting plate ground wire and secure with
the wire connectors provided. After wires are
connected, tuck them carefully into the ceiling
junction box.
COMPLETING THE INSTALLATION (Fig. 1)
11. Align canopy (C) to mounting plate (A) and secure
with mounting screws (D) into slots (T).
12. Install the light bulbs (R) (Supplied ) in accordance with
the fixture’s specifications. (DO NOT EXCEED THE
SPECIFIED WATTAGE!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig.2
- Mounting plate
- Ground screw
- Mounting screws*2
- Junction box screws*2
INSTALLATION INSTRUCTION