Owner Manual

Step 2
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diaram
below. Be prepared, the parts are reasy.
å
Fasten the EXTENSION RAILS (40MA) to the ENDS (A and B). Use eiht SILVER 1/2" FLAT HEAD SCREWS (128S)
throuh holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlared diaram. Then, slide the
inner cartride of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Push the black lever in and pull the SLIDE from the RAIL.
40MA40MC
3
2
1
1
2
3
4
4
Pae 8
A
B
SILVER 1/2" FLAT HEAD SCREW
(8 used for the RAILS)
128S
3
2
1
4
1
2
3
4
Open end
Open end
These small holes
must be here.