Caution : You must read this before you proceed CLUB CHAIR Picture Label Picture Description QTY A Chair Seat 1 B Front Leg 2 Page 1 OF 5
C Hind Leg 2 Description QTY ① Bolt (M8X60mm) 9 ② Washer 9 ③ Spring Washer 9 ④ Allen Key 1 Label Picture Before Beginning Assembly: Page 2 OF 5
Overview Chair Seat(A) Front Leg(B) Hind Leg(B) FRONT FACING This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Chair Seat(A) Place the Chair Seat(A) facedown on a clean, non-marring surface, as shown in picture above.
Step 3 ③ ① ② ④ Insert one Leg(B) into the mounting position of Chair Seat(A) and attach using Bolts(①), Washers(②) and Spring Washers(③) with Allen Key(④). Please note the Front Leg(B) and Hind Leg(C) is different, there are mark on the leg. Do not fully tighten the Bolts. Repeat the same process to attach the remaining three Legs. Step 4 Zip up the dust cover at the bottom of the Chair. Stand the Chair up. Your Chair ready for use. This Chair can only be used on a flat, level surface.
Page 5 OF 5
