Owner Manual

Part J.

SAFETY INFORMATION - OPERATIONS

Before performing a leak test, be sure:

1. ) DO NOT press the Ignitor .

2. ) You are in a spacious outdoor area.

Connect the Propane Gas tank to the Regulator (12 /19) and turn the Valve (22) on the unit to the “OFF”

position.

Brush soap and water mixture onto all connections.

Turn the gas supply on;if extra large bubbles form on any connection there may be a leak. If you smell

gas or a leak is discovered, IMMEDIATELY turn the gas valve off, disconnect Propane Gas tank.

Do not use the appliance until the leak is repaired

The Fire Table / Column has a Door. Remove the Door and leave the Door on the floor. Inspect the Gas

Hose (12) before use the Fire Table / Column.

If there are signs of wear or abrasion on the hose, you must replace the Gas Hose (12).And the Gas Hose

must be supplied directly by

manufacturer.

Lava rocks / pumice stones could pop up and strike somebody’s face during the process of lighting this

unit.

Stand away from the Fire Table / Column for the initial 20 minutes after igniting.

Observe flame colour and flame height when the

Fire Table/Column after being lit :

1. ) Flame color should be yellow / blue.

2. ) Flame height burns at 2 - 10 inches high.

Wait 10 minutes after extinguishing flame prior to replacing a lid (if applicable) or protective cover onto

the Fire Table / Column.

2 inches to 10 inches.