Installation & Assembly

Page 4 of 5
Turn right (clockwise) to tighten
I. With the help of another person, carefully place the dresser (#1)
on its back over a protected surface.
II. Align the threaded end of the 4 feet (#4) with the pre-drilled holes
on the bottom corners of the dresser (#1) and tighten by hand
until secured.
III. Align the threaded end of the center foot (#5) with the pre-drilled
hole on the center of the dresser (#1) and tighten by hand until
secured.
Turn right (clockwise) to tighten
I. Align the two support rails (#3) vertically with the pre-drilled holes
of the dresser (#1).
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#B)
onto the bolt (#A) and then the flat washer (#C) onto the SAME bolt
(#A), in that order.
III. Insert the bolt assemblies through the support rails (#3) and secure
those bolts using an Allen wrench (#D) to lock with the dresser
(#1).
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs