Assembly Instructions

ManualsBrandsFoundry Select Manuals2 Seat Kitchen & Dining TablesGarcia Counter Height Drop Leaf Dining Table

Table Of Contents

P.1

Summary of content (19 pages)

PAGE 2
General Assembly Guidelines I. Ensure that all parts and hardware are available before beginning assembly. II. Follow each step carefully to ensure the proper assembly of this product. III. Two people are recommended for ease in the assembly of this product. IV. The three main types of hardware used to assemble this product are: wood dowels, screws and bolts. V. The provided glue is to secure wood dowels in place.
PAGE 4
Hardware List A Ø8x30mm Wooden dowel 14 pcs B Ø6x35mm Cam bolt 15 pcs C Ø15x11mm Cam lock 15 pcs D Ø30mm Sticker 15 pcs Hinge 3 E pcs F Ø4x12mm Screw 12 pcs G Ø6x50mm Bolt 8 pcs H Shelf support pin 8 pcs J Rubber Pad 2 pcs K Ø1/4"x12mm Bolt 8 pcs M Ø1/4"x25mm Flat head Bolt 4 pcs N M4 Hex key 1 pc Glue tube 1 pc Bolt 4 pcs P Q Ø1/4"x25mm Philips head screwdriver required for assembly (not included) The hardware quantities listed above are required
PAGE 5
Step 1 A A A B A A A 2 8 6 7 9 A B A A A B B B B Insert wooden dowel (A) into parts (2,6,7,8,9), then using cam bolt (B) secure parts (6,8) with Philips head screwdriver as per diagram. All rights reserved. P.
PAGE 9
Step 5 M M N G 12 3 N 2 M M 3 G 11 N G M Using bolt (M) attach parts (3) into parts (11,12) ,use bolt (G) attach part (2) into parts (11,12)with hex key (N) as per diagram. All rights reserved. P.
PAGE 14
Step 10 N K K K K 4 13 N 1 K J K K 13 4 5 J 1 1 5 5 Attach rubber pad (J) on part (5) as the diagram .please keep the rubber (J) and part (4) in the same line .In this way when you pull out the leaf support (4).it could be on the rubber pad (J). Using part (13) cover part (4).then use bolt (K) secure part (13) to part (1) with hex key (N )as per diagram. All rights reserved. P.
PAGE 15
1 Step 11 2 3 1 Q C 2 Q C C C Q Q Q C C 6 8 11 N Using bolt (Q) secure part (1) into part (11,12) with hex key (N) , then using cam lock (C) secure part (1) into parts (2,6,8) with Philips head screwdriver as per diagram. All rights reserved. P.
PAGE 17
Step 13 6 H H H H 10 8 H H H 10 10 H Insert shelf support pins (H) into parts (6,8) ,make sure you place the four support pins (H) in the same level so the shelf is not tilted .Then put part (10) into parts (6,8) as per diagram,tilt and rest the adjustable shelves (10) onto the shelf support pins (H) . All rights reserved. P.
PAGE 18
Step 14 4 13 13 4 Note : If you want to open the leaf ,please lift up the leaf as shown. Hold it .then fully pull out the two leaf support and keep them on the rubber pad If you want to close the leaf .please lift up the leaf slightly and hold it.push the two leaf supports off .Then lay down the leaf slowly . All rights reserved. P.