User Manual

STEP 1 - Rear Axle and Brake Assembly

1. LayfoldedStroller Frame Assembly (A)on

 cleanoorwithhandletube(1)ontopandfront

 footrests(2)contactingoor(Fig. 1).

2. AssembleRear Axle Tube Assembly (C)

 tostroller(Fig. 2).

  - PositionRearAxleTubeAssembly(C)withbrake

   tube(3)upandopenendofrearaxle

   assembliestowardrearlegs.

  - Sliderearaxletubeassembly(C)ontothe

   lowerendsofrearlegs(4)untilcontacting

   springpins.Pressspringpinsandslide

   rearaxleassembly(C)ontorearleg(4)until

   springpinssnapintoholesinrearaxle

   tubeassembly(C).

  - PullonRearAxleTubeAssembly(C) tocheck

thatitissecuredontorearlegs.

Fig. 2

Fig. 1

Style May Vary

STEP 2 - Rear Wheel Assembly

1. AlignholeinrearaxlerodofRear Wheel With Axle B with

 holesinRearAxleTubeAssembly(C).Sliderearwheelwith

axleBintoRearAxleTubeAssembly(C)(Fig. 1).

2. SlideRear Wheel With Axle (B)inuntilholeinrear

 axlerod1alignswithholeinrearaxletube.

3. InsertM6 x 34 mm Screw (H) throughRearAxleTube

 Assembly(C)andrearaxleroduntilscrewcomesoutbottomof

 RearAxleTubeAssembly(C)(Fig. 2).

 NOTE:Ifendofscrewdoesnotslideintohole,check

  alignmentofholeinaxle.Ifholeinaxleisnot

  aligned,removerearwheelandstartover.

4. InsertM6 Nut (I) into6-sidedrecessonbottomof

 rearaxletubeandusingphillipsscrewdriver,secure

 Screw(H)byturningintonutuntiltight(Fig. 3).

 Repeatsteps2thru4foroppositerearwheel.

Fig. 1

Fig. 2

Fig. 3