Installation Guide

INSTRUCTIONS FOR USE
CLEAN-UP
PRODUCT REMOVAL
PRECAUTIONS AND LIMITATIONS
ARMOR UTN60
EPOXIES, URETHANES, ETC.
SURFACE PREPARATION: Surface preparation will vary according to the type of complete system to be applied. ARMOR UTN60 is designed to
be applied only to primed surfaces within the recommended recoat window of the primer or previously sealed surfaces that have sufficient adhesion
to the substrate. Apply coating to a clean surface that is completely dry and free of oil, dirt, grime, wax, detergent or any incompatible paint or coat-
ing. If applying to an existing fully cured coating the surface must be cleaned and prepped to a 40-80 grit finish If multiple coats of ARMOR UTN60
are required apply the second coat as close as possible to the suggested recoat time (see technical information section on this data sheet). Do not
exceed 24 hours to recoat or a light sanding will be needed for adequate adhesion between coats.
PRODUCT MIXING: Pour a full pre-packaged kit of 2 parts of Part A to 1 part of Part B together and mix well with slow speed mixing equipment
such as a jiffy mixer until the material is thoroughly mixed and homogenous. Avoid whipping air into the coating. Improper mixing may result in prod-
uct failure.
PRODUCT APPLICATION: Apply the mixed material by brush or roller with a 3/8”- 1/2” nap shedless roller cover within the usable pot life time
frame, as well as the recommended temperature and relative humidity guidelines listed in the Technical Information section. If the material becomes
thick while applying and sticking to the roller , stop applying and discard the mixed material. At this point it has reached the end of the usable pot
life. While applying keep a wet edge to prevent roller marks. It is recommended to work in sections usually using control joints as dividers to ensure
proper application results. Do not allow to Puddle! If recoating after 24 hours a light sanding using a fine sanding screen may be needed to ensure
adequate inner coat adhesion.
PLEASE NOTE: Applying ARMOR UTN60 outside of the suggested parameters may result in job failure. It is always recommended to test the
product in a small, inconspicuous area (on the same concrete substrate) for desired results prior to application. Coverage rates may vary for all
coatings and substrates depending on porosity, density, texture etc.
Use MEK. Dispose of containers in accordance with local and federal regulations.
Dried, cured urethane may be removed with a commercial stripper, but recommended removal is by way of mechanical
means, including sanding, shot blasting, etc.
►All new concrete must be cured for at least 28 days prior to application.
►Coverage rates depend upon many conditions including application method, surface porosity, applicator, ect.
►ARMOR UTN60 should be applied in thin coats. Do not puddle.
►Be aware that this product may be slippery when wet. Anti Slip additives may be needed to reduce surface slip hazards.
►ARMOR UTN60 may darken the surface of many new and existing concrete substrates. Test prior to use.
►Physical properties listed on this technical data sheet are typical values not specifications.
•• If applying over an existing coating, proper adhesion and compatibility tests are essential. In this application the substrate
preparation, application, performance and all other liabilities are strictly the end users responsibility. Foundation Armor
offers no guaranty, warranty or other claims to the success or results of the job in this circumstance.
SPECIAL NOTES
Please consult Material Safety Data Sheet (MSDS) and read Warranty information prior to use. This information can be re-
quested by contacting customer service at 866-306-0246.
FOUNDATION ARMOR
3 Bud Way STE 27, Nashua, NH 03063
Phone: [phone]
Visit us online at: www.FoundationArmor.com