User guide

43
2
3
1
2
Loosen the head by giving the handle a few of turns;
Slide and clamp the 1” hole to the rst extension pole
To attach the arm to the second head
locate the 7/8” hole and loosen the head
by giving the handle a few turns
Slide arm in and tighten
the head to lock arm in position
To mount the rotating heads
to the 8ft stand, locate the 1”
hole on one of the heads
assemblinG the RefleCtoR assemblinG the RefleCtoR
assemblinG the RefleCtoR
The Rotating Heads The Rotating Heads
The Arm
Instructions for the 8ft stand
2
3
Without loosing sight of the 3/4” hole, detach half of
the head by unscrewing the handle and clamping it
to the second extension pole
NOTE: Careful not to loose the spring or washers
Line up studs
and holes together
3/4”
Screw back
together tightly
Screw back
together tightly
NOTE: The 6ft stand’s rst extension pole is too thin to hold the rotating head
To mount the rotating heads to
the 6ft stand, locate the 3/4”
hole on one of the heads
Instructions for the 6ft stand
1”
7/8”