Digital Multitracker Owner's Manual VF08

34
Basic Recording/Playback
3
4
2
3
4
1
MASTERING TRAINING
EFFECTEQPAN
SCENE SEQ.SCENE
TRACK
MIX PARAMETER
PGM
FADER
MAP
ON/OFF
2TRK MODE
BOUNCE MODE
EDIT
[EFFECT] key
2
5
6
4
Blinking
Highlight the “Lo Gain” field by using the [CURSOR
down] key, and edit the “Lo Gain” value using the [JOG]
dial.
You can set the value between -18 dB and + 18 dB, as
same as the Hi Gain.
Repeat steps 2 through 4 to edit EQ on other tracks.
After completing the EQ setting, press the [EXIT/NO]
key.
The LCD returns to the Normal screen.
Setting effects
Press the [EFFECT] key.
The effect send level setting screen appears initially.
Each press of the [EFFECT] key switches between the
effect send level setting screen, effect type selection
screen and effect send pre/post selection screen.
Effect send level setting
While the effect send level setting screen is shown,
press the [TRACK STATUS/TRACK SEL] key of the
desired track.
The effect knob icon of the selected track is highlighted,
showing that it can be edited.
The default value for track sends 1 through 6 is “0” while
the default value for the master is “80”.
Use the [JOG] dial to enter the send level.
While the send level changes, the corresponding icon
also changes in real time.
When the value increases, the effect sound of the cur-
rently selected effect type will be output.
To set the effect send levels for other tracks, carry out
step 2 and 3 above repeatedly.
Effect type setting
<Effect type setting>
The VF08 provides 38 effect types in the effect library.
You can select any one of the types depending on the
usage. See “Mixer functions” for details about the effect li-
brary.
Bring up the effect type setting screen and select the
desired effect type by rotating the [JOG] dial.
While rotating the [JOG] dial, the effect type appears
one after the other among 38 types.
After selecting the desired effect type, press the [EN-
TER/YES] key.
The selected effect type is set.
Press the [EFFECT] key to bring up the effect send level
setting screen.
Adjust the effect send levels as described above.
<Pre/post setting of effect sends>
All the effect sends from tracks 1 through 6 are
initially set to “post-fader”. Therefore, when a
track fader is completely down, no signal is sent
even if you raise the effect send level of the track.
You can also select “pre-fader” if necessary.
See “Mixer functions” for details.
<Parameter setting for each effect type>
You can set parameters for the selected effect
type. See “Mixer functions” for details about pa-
rameter setting.
<On/Off setting of the effect>
You can switch on or off the effect alternately
by pressing the [EFFECT/
ON/OFF] key while
holding down the [SHIFT] key.
See “Mixer functions” for details.
5
highlighted
This section describes how to set the effect send lev-
els and how to select the effect type.
You can also perform pre/post setting, effect param-
eter setting, etc. See “Mixer Functions” described later
for details.
Highlighted