User Manual

p-7
Back Panel Overview
1. Input
The XLR out of XLR/PHONE combo con-
nector is used for inputting the electrically
balanced input signal. The PHONE out of
XLR/PHONE combo connector as well
as the RCA jack next to the XLR/PHONE
combo connector are used for inputting the
electronically unbalance d input signal.
* CAUTION: Do not input the signals
to the XLR connector and RCA jack or
PHONE connector and RCA jack at the
same time. If you do so, both the signals are
mixed and output.
2. Continuously variable gain control
This control adjusts the input level to the
internal ampliers.
3. Power Switch
Turns the power to the amplier section on or off. On-position is the spot side.
4. AC IN
Connects the supplied AC cord.
• Auto Stand-by Mode
When no input signal continues for about 13 minutes or so, the PM0.5d will go into the stand-by
mode automatically and reduce the power consumption. This is indicated by the red lighting power
LED. In the normal operation mode, the power LED is lit in blue. If the input audio signal comes in
again, it will automatically return to the normal operation mode again.
Step 4: Power up all the equipment and then turn on the PM0.5d last.
Step 5: Set the gain of both speakers at medium setting and slowly bring up the gain of the console.
Step 6: Adjust the gain of both monitors for balance and for best signal to noise ratio.
Once the above steps have been completed, you are ready to use your PM0.5d. It is recommended
that you now play some familiar audio material and make any nal adjustments, as far as placement
or level, to get the optimum performance in your monitoring environment.
VOLUME
MIN MAX
INPUT
RISKOFELECTRICSHOCK
CAUTION
PersonalActiveSpeakerSystem
ATTENTION
PM0.5d
WARNING:
TOREDUCETHERISKOFFIREORELECTRICALSHOCK,
DONOTEXPOSETHISEQUIPMENTTORAINORMOISTURE,
DONOTREMOVECOVER.
NOUSERSERVICEABLEPARTSINSIDE.
REFERSERVICINGTOQUALIFIEDPERSONNEL.
DONOTOPEN
POWER
OFFON
N2215
PS
E
D
I
S
T
E
L
C US
3012110
ANSI/ULSTD.60065
CONFORMSTO
Intertek
ACIN
CAN/CSASTD.
C22.2NO.60065
CERTIFIEDTO
MADEINCHINA
100-240V~50/60Hz
CM
FOSTEX
100V-240V~60W50/60Hz
FOSTEXCO.
SERIALNo.
0960001UV
PersonalActiveSpeakerSystem
MODELPM0.5d
NESPASOUVRIR
RISQUE Dʼ ÉLECTROCUTION
2
1
3
4