User Manual

3
Passive speaker (left channel)
This unit plays back left channel of the stereo audio
source fed to the active speaker.
❻
[L-IN] connector
Connects to the [L-OUT] connector of the active
speaker using the supplied speaker cable.
<Note>:Do not connect to the [INPUT A] con-
nector when you use the [INPUT B] connectors.
If you connect to the [INPUT A] connector, the
[INPUT B] connectors are disabled.
Active speaker (right channel)
This unit comprises a speaker section for playing
back right channel and a built-in stereo amplier.
❶
[VOLUME] control
Controls the audio volume as well as turns on or off
the power.
❷
[INPUT A (L, R) ] connectors (RCA jacks)
Connect to a stereo sound source such as a CD
player and DJ mixer.
❸
[INPUT B] connector (stereo mini jack)
Connects to a stereo sound source, such as a per-
sonal computer and portable music player, using
the supplied stereo mini plug cable.
❹
[L-OUT] jack
Connects to the [L-IN] connector of the passive
speaker using the supplied speaker cable. A left
channel signal of the stereo audio source fed to the
[INPUT A] connectors or [INPUT B] connector is
sent to the passive speaker via the built-in amplier.
❺
[DC IN] connector
Connects the supplied AC adaptor.
Functions and connections
The PM0.3d consists of an active speaker that has
a built-in amplier and a passive speaker that does
not have an amplier.
<Note>:The power must be off when you make
connections.
<ErP Directive>
The PM0.3d conforms to ErP directive and pursues
energy efciency. Thus, when no-signal continues
for about 12 minutes or more, it will automatically
go into the stand-by mode and its power withdraw-
al will become as low as 0.4W. During this mode,
the power LED will change from Blue to Red.
PM0.3
L-IN
to wall outlet
AC adaptor
Active speaker Passive speaker
Headphone
output
Supplied speaker
cable (1.5 m)
Supplied stereo
mini plug cable
(0.8 m)
Personal computer or
portable music player
❷
❶
❸
❹
❻
❺
CD player
Headphone
output
Line
output
Attaching feet
If you want to tilt the speakers
upward, prepare 4 pcs. feet in-
cluded in the package, peel off
the protection sheet covering
the adhesive surface of foot
and attach 2 pcs. each of feet
at the bottom of the speakers.
Especially after attaching the
feet, place the speakers at a
stable surface so that they will
not fall over.