Instructions / Assembly

Lava Rock & Glass Application
Please follow the instructions below to add the finishing touch to your fire pit. Remember the deeper your lava rock or
glass the more risk of reducing if not smothering the flame. Particular attention needs to be on the pilot assembly area.
Incorrect media installation will cause the pilot flame to suffocate and turn off pit or delay main burner ignition.
Lava Rock Only Application
1) Install your fire pit per instructions.
2) Apply lava rock ONLY deep enough to cover ring and pan-
less than 2” above fire ring.
For Electronic Ignition
3) Blow Out Box: Do not cover vents with lava rock- leave
open. Do not allow any rock to block flame opening.
4) Blowout Box: Do not cover blowout box vents or
opening with lava rock or glass. Incorrect media
installation will cause the pilot flame to suffocate and
turn off pit or delay main burner ignition.
Decorative Glass Application
1) Install your fire pit per instructions.
2) Fill Pan with glass. Cover Burner with 1/8” to ¼” of
glass. Do not over fill with glass. All LP installations
must be checked for back pressure with media installed.
Failure to do so may result in personal injury or
property damage.
For Electronic Ignition
3) Blowout Box: Do not cover blowout box vents or
opening with lava rock or glass. Incorrect media
installation will cause the pilot flame to suffocate
and turn off pit or delay main burner ignition.
DO NOT COVER VENTS! DO NOT COVER PILOT
OPENING!